Don’t have a dyno tuning center nearby? Are you more of a D.I.Y. (do it yourself)
type? Are you constantly changing parts on your vehicle? If you answer "yes" to
any or all of the questions above, then our CMD AutoTune kit is for you.
The Dynojet AutoTune feature is enabled by using our
WideBand 2 oxygen sensor monitor with any of our CMD’s. It
connects to the CMD with a single cable and requires only a ground and +12 volt
connection to be made to install. If your exhaust does not already have one, a "weld
in" O2 sensor bung is included.
We have taken virtually the same technology that our patented Tuning Link dynamometer
software (for automated Dyno tuning), along with Bosch Wide Band O2 sensors and
miniaturized it to be used on your vehicle while you drive. Once installed, the
CMD AutoTune kit monitors the fuel mixture in real time (by using the included Wide
Band O2 sensor in the exhaust).
It then sends this information to the CMD and automatically corrects it while you
drive. Air/fuel ratio targets are fully adjustable from within the software. Each
MAP or MAF point/rpm combination is individually adjustable.
The CMD AutoTune kit can be configured to run and correct in any open-loop area.
You can also configure the AutoTune kit to wait a preset amount of time before beginning
to make adjustments.
The CMD AutoTune kit is NOW AVAILABLE directly from Dynojet Research, Inc.
For more information or to place an order please give us a call, toll free at: 1-800-992-4993.
Or simply use or online shopping cart to place an order. Buy option is below.